Dehumidifying; Setting The Timer; Safety Standby Light; Bucket Full Light - LG UD501KOG5 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dehumidifying

1
Press
to turn on the power.
- It takes 30 minutes of continuous
operation to reach the desired humidity
level the first time the product is used.
- The display shows the current humidity
level.
2
Press
/
to change humidity.
- The desired humidity level can be set in
5-percent increments from 30-80%.
- The display shows the desired humidity
level while it is being set, then reverts to
the current humidity level after 5
seconds.
- The current humidity level is displayed in
5-percent increments from 25-90%.
If the humidity level is outside the range,
the display continues to show either 25%
or 90%.
3
Press
to change the fan speed.
The fan speed has two levels: low or high.
4
Press
to turn off the product.
NOTE
!
• If the product is restarted immediately
after being shut down, to protect the
compressor there is a 3-minute delay
until the compressor begins operating.
• It is normal for the compressor to cause
the product to vibrate while starting or
stopping.

Setting the Timer

1
Press
to turn on the power.
2
Press
to set the automatic shut off
time.
- Press the button repeatedly to increase
the time until shut off in 1-hour
increments up to 12 hours.
3
Press
to cancel the Timer function.
- Press the Timer button repeatedly until
the Timer On light turns off.
NOTE
!
Empty the drain water bucket before
setting the Timer function.
If the water bucket becomes full during
the Timer function, the Bucket Full light
goes on and dehumidification stops.

Safety Standby Light

- After 23 hours of continuous operation, the
red Safety Standby light turns on for one
hour and the fan and compressor shut off to
prevent product malfunction.
- After an hour with the fan and compressor
shut off, the Safety Standby light turns off
and the fan and compressor automatically
restart.

Bucket Full Light

- Empty the water bucket within three
minutes of the Bucket Full light turning on.
- After the light turns on, the fan operates for
an additional three minutes to remove
remaining condensed water and then the
product shuts off.
- See Emptying the Water Bucket for further
instructions.
OPERATION
7

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido