Operation - Lacor 69488 Instrucciones De Uso Y Mantenimiento

Installation:
1.- Before using the item for the first time, clean the accessories that will come into contact with food.
2.- Position the main body (12) on a flat surface.
3.- Lower the safety lever (11) to enable you to assemble all the juicer's accessories (PHOTO 1).
4.- Place the juice container (8) on the main body so that the juice outlet nozzle is aligned with
the groove (PHOTO 2).
5.- Place the head support (7) on the juice container. In order to ensure correct assembly, the rib
of the support must be aligned with the straight part of the container (PHOTO 3).
6.- Place the filter (6) on the support. Turn the filter until the motor shaft is aligned with the filter
groove (PHOTO 4 - 5).
Exercise extreme caution when handling the filter as it has very sharp blades. The use
of cut-resistant gloves is recommended.
7.- Place the head (4) on the filter; the head tabs must be aligned with the notches on the support
(PHOTO 6).
8.- Finally, place the tray (1) on the head (PHOTO 7).
9.- Once all the pieces are in position, push the safety lever up to lock all the components in place
(PHOTO 8).
NOTE
: Make sure that the handle is properly closed. If not, the juicer will not start.
10.- Place the waste container (10) on the back of the appliance, under the head discharge.
1
4
7

OPERATION

2 3
5 6
8
OK
33