Prestige Audiovox Platinum APS-700 El Manual Del Propietario página 4

All manuals and user guides at all-guides.com
SILENT DISARMING:
As you approach the vehicle, press and hold the arm/disarm button of your key chain trans-
mitter for two seconds.
The parking lights will flash twice, and the dash mounted LED will turn off confirming that the
system is disarmed. If you have the optional door lock/unlock circuit installed, the doors will
unlock. If you have the optional entry illumination circuit installed, the interior light will turn on
for 20 seconds or until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted LED
will start flashing rapidly indicating that the system is rearming. Opening any door will sus-
pend the automatic arming.
If the parking lights flashed three times, and the siren chirps four times, this indicates that the
alarm system had been triggered during your absence. Before turning on the ignition key,
examine the dash mounted LED's flash pattern. The number of flashes identifies the triggered
zone. For additional information, refer to INTRUSION WARNING SIGNALS found later in this
manual.
INTRUSION WARNING SIGNAL:
This system will inform you if an intrusion attempt has occurred while you were away from the
vehicle. Upon disarming the unit, the siren will chirp 4 times and the parking lights will flash 3
times. Enter the vehicle and before turning on the ignition switch, observe the LED flash
pattern.
If the LED flashes one time...pause, one time...pause etc., then an intrusion attempt was
made by impact or a strong vibration that the shock sensor detected. Check the vehicle for
possible damage to the glass or body panels.
If the LED flashes two times...pause, two times...pause etc., then an intrusion attempt was
made to open the hood, trunk, or by an accessory triggering device. Check the vehicle for
indications of forced entry to these openings.
If the LED flashes three times...pause, three times...pause etc., then an intrusion attempt was
made to the vehicle doors. Check all doors for indications of forced entry.
NOTE: The LED intrusion warning indications are stored in the system's memory and will be
erased when the ignition switch is turned on.
VALET SWITCH:
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your keychain transmitter to parking attendants or garage mechanics. When the system
is in the valet mode, all alarm functions are bypassed, however the remote panic feature, and
the optional remote door lock/unlock will remain operational. To enter the valet mode;
1. Start with the valet switch in the "off" position
2. Turn the ignition switch to the "on" position.
3. Within 10 seconds of step 2, move the valet switch to the "on" position.
The dash mounted LED will turn on solid indicating that the valet mode has successfully been
entered.
To return to the normal, (alarm mode), operation, move the valet switch to the "off" position
any time the ignition switch is in the on position.
NOTE: Always remember to move the valet switch back to the off position. This will ensure
that the vehicle remains protected at all times.
4