Black and Decker LCSB2140 Manual De Instrucciones página 8

ASSEmbly
WARNING:
Before assembly, make
sure the bail handle (2) is released and
the safety key (3) is removed.
HANDlES
• To engage the handle bar, pull upwards
on the upper frame (15) as shown in
figure 2.
• Secure the connection of the lower
frame (17) to the middle frame (14) by
fastening the handle bolts (18) and
frame knobs (6) on each side as shown
in figures 3 & 4.
• Secure the connection of the middle
frame (14) to the upper frame (15) by
tightening the handle bolts and frame
knobs (6) on each side as shown in
figure 5.
2
3
4
6
16
5
15
6
14
All manuals and user guides at all-guides.com
18
17
6
6
8
DISCHARGE CHUTE
• Place the chute deflector / guard (11) onto
the discharge chute (10) so the bolt holes
align and the deflector handle is pointing
towards the handle bar (1).
• Insert a chute gasket (19) in between the
chute connection and secure the assembly
with a carriage bolt (20) and a deflector
knob (12) on each side of the chute deflector
/ guard as shown in figures 6, 7 & 8.
• Slightly loosen the knobs (12) and
position the chute deflector / guard to
the desired height of the snow stream.
Tighten knobs (12) to secure its position.
NOTE: Do not overtighten the deflector knobs.
CHUTE ROTATION ROD
• Insert chute rotation rod (5) through the
hole in the eye hook (21) located on the
middle frame (14) as shown in figure 9.
• Locate the chute rotation coupler (22)
on the main housing.
• Insert the chute rotation rod into the
chute rotation coupler (22). Secure the
assembly with the supplied retaining pin
(23) by aligning the pin holes on the rod
and coupler and fully insert retaining pin
as shown in figure 10.
6
7
11
20
19
10
9
21
5
19
8
12
10
22
23
5