Connections, Operating And Display Elements; Led Display; Control Buttons - Cameo LED GOBO SCANNER 80 Manual De Usuario

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
POWER IN
IEC mains socket with built-in fuse holder. A suitable power cable is included.
IMPORTANT NOTE: Replace the fuse only with a fuse of the same type and of the same value according to the stamp on the device! In the
event of repeated fuse failure, please contact an authorised service centre.
2
POWER OUT
IEC power output socket. Facilitates power supply to other CAMEO spotlights. Ensure that the total current consumption of all connected
devices does not exceed the value specified on the device in amperes (A).
3
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
4
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
5

LED DISPLAY

The four-digit LED display shows the current operating mode and other system settings.
6

CONTROL BUTTONS

MODE: Selection of the main menu items. Move up one level in the menu structure.
ENTER: Confirms programme selection and value changes.
UP and DOWN: Selection of operation mode, system settings and programmes, e.g. changing of programme speed and DMX address.
7
MIC
Microphone for music-control mode
All manuals and user guides at all-guides.com
1
5
7
6
3
2
8
4
5