Vimar ELVOX EMC.W Guía Rápida Para El Instalador página 6

EMC.W
Description
Wi-Fi module for connection of control panels and .W series receivers to Android and iOS smartphones via the Wi-Gate
app
Connection
Connect the module to the CNX1 connector of the .W series electronics.
The EMC.W module can also be inserted and removed to powered boards without any damage, but power fluctuations
could cause the board on which the module is inserted to be rebooted in the event of hot connections.
DIP functions
Dip Function
DIP 1 Module reset
DIP 2 No function
DIP 3
Reserved
DIP 4
DL1 LED functions
Colour Status
Status
On steady
Green
Slow blink
Fast blink
Red On steady
4
Status Description
OFF Module in normal operation
Module reset, resets the default settings on the module. To reset the
default settings move the Dip to ON and reboot the board to which
the module is connected. As soon as the DL1 LED starts to blink
green, turn the Dip to OFF.
Settings reset:
Mode: Access point
Network name (SSID): VIMAR_XXXXX (as per module label)
ON Channel: 11
Security: Open
IP address: 192.168.1.1
Netmask IP: 255.255.255.0
DHCP: On
DHCP range: 192.168.1.2
Resetting the default settings of the module is useful above all if the
password associated to the network is forgotten.
Always leave OFF
Description
Description
Module in start-up.
When started up the module scans the available Wi-Fi networks and shows them
in the configuration page in Station mode. Every 30 minutes the available networks
are updated.
Wi-Fi module ready for connection in Access Point mode
Wi-Fi module connected via TCP (e.g. via APP) in Access Point mode.
Connection via browser is not shown as a TCP connection, and when accessing
the configuration page the module blinks slowly
Module connected to an existing Wi-Fi network
EN