Agri-Fab LBD48D Manual De Usuario página 8

STEP 5:
(SEE FIGURE 5)
• Attach the Rear Locating Bracket to the top of the
Rear Mounting Bracket using two 3/8" x 1" Carriage
bolts and 3/8" nylock nuts. Tighten nuts.
• Attach the Rear Support Channels to the middle set
of holes in the sides of the Rear Mounting Bracket
using four 3/8" x 1" Carriage Bolts and 3/8" nylock
nuts. Finger tighten only.
REAR LOCATING REAR SUPPORT
BRACKET CHANNELS
REAR MOUNTING
BRACKET
FIGURE 5
STEP 6:
(SEE FIGURE 6)
• Slide the Rear Support Channels under the rear of
the tractor. Attach the Rear Mounting Bracket to the
Tractor Drawbar using the 5/8" x 1-3/4" Clevis Pin and
a large Hairpin Cotter.
5/8" x 1-3/4"
CLEVIS PIN (K)
REAR
MOUNTING
BRACKET
LARGE
HAIRPIN
COTTER (M)
FIGURE 6
STEP 7:
(SEE FIGURE 7)
• Slide the Thrust Channel under the front of the tractor.
Attach the Hanger Brackets to the Frame Brackets or
Deck Suspension Brackets using two 1/2" x 1" clevis
pins, 1/2" washers and large hairpin cotters.
THRUST
CHANNEL
1/2" WASHER (S)
LARGE HAIRPIN
COTTER (M)
FIGURE 7
3/8" x 1"
CARRIAGE BOLT (F)
3/8" NYLOCK NUT (I)
REAR LOCATING
BRACKET
REAR SUPPORT
CHANNEL
1" x 1/2" CLEVIS
PIN (L)
ENGLISH
STEP 8:
(SEE FIGURE 8)
• Place the Thrust Channel between the two Rear
Support Channels. Install four 3/8" x 1" carriage bolts
and 3/8" nylock nuts using the most widely spaced
holes that align with slots. Finger tighten only.
• If the Rear Support Channels bump against the
bottom of the tractor, reattach the rear of the channels
to a lower set of holes in the Rear Mounting Bracket.
If there is more clearance than necessary between
the Rear Support Channels and the bottom of the
tractor, reattach the rear of the channels to a higher
set of holes in the Rear Mounting Bracket.
• Tighten all bolts and nuts installed up to this point.
• Measure the height of the front plate on the Thrust
Channel. If it is not 4" to 5" above the ground, reinstall
the clevis pins in the Hanger Brackets to a higher or
lower hole position to attain the correct height.
3/8" NYLOCK
NUT (I)
FIGURE 8
STEP 9:
(SEE FIGURE 9)
• Assemble the pivot support bracket to the front of the
Thrust Channel using four 3/8" x 1" carriage bolts and
four 3/8" nylock nuts. Make sure the bracket is straight
and then tighten.
FIGURE 9
8
REAR
SUPPORT
CHANNELS
3/8" x 1"
CARRIAGE BOLT (F)
FRONT
PLATE
3/8" x 1"
CARRIAGE BOLT (F)
"
t o 5
4 "
3/8" NYLOCK
NUT (I)