Blunt/Envy Scooters ATS Pro El Manual Del Propietario página 6

5mm Allen
Key
Attention
:
in case one of
the axle bolts is not realeasing,
insert a 5mm Allen Key into the
center of the axle to lock it, this
will allow you to undo the bolt.
the bearing covers and allow the oil to sink in. If the wheels do not spin
freely after this you will need to replace the bearings.
Inflating and deflating your tires
When inflating your tires remove the cap off the nozzle
and attach the pump, make sure not to exceed the rec-
ommended pressures written on the side of the tyre.
When deflating your tires, remove the nozzle cap and
push the pressure pin of the nozzle until completely de-
flated, proceed with caution.
All manuals and user guides at all-guides.com
Maintenance Maintenance
Lubricating your bearings
Removing Wheels
You will have to take off your wheels to
lubricate your wheel bearings this is done by
taking 2x8 mm Allen Keys, take out one of
the axle bolts then insert the Allen key in the
axle to lock it down and continue taking out
the other bolt. The wheels may need some
encouragement to slide out.
Cleaning and Lubricating
Using a damp cloth wipe off any dirt or grime
on your wheels and bearings. Using bicycle-
bearing oil, place 3 to 4 drops directly on
6