7. When the instrument heating element is activated, the UPS emits a tone that will last until the heating element is
deactivated. The amount of heat delivered in variable mode by the instrument heater may be adjusted by
pressing the "+" or "-" push pads on the right side of the UPS. The numerical setting is shown on the LED bar
graph above the push pads. Increasing the LED's numerical value setting increases the amount of heat delivered
by the instrument. Generally, lower heat ranges increase the sealing capabilities and increase the time required to
divide tissue. Higher heat ranges decrease the time to divide and may decrease seal integrity.
8. At the end of the surgical procedure, turn the UPS off and disconnect the Microline Cautery Instrument and if
applicable, the PowerPack Dual Control Footswitch.
Handling, Storage And Cleaning
• Do not drop. Store in a cool, dry place. Avoid prolonged exposure to extreme temperatures.
• Exterior of the UPS may be cleaned using a soft cloth moistened with a solution of water and a mild
detergent or disinfectant (such as Cidex or Sporicidin).
• Do not immerse the UPS in liquids.
Recommended Environmental Conditions
Transport
-15ºC to 40º
10 to 95
700hPa to 1060hPa
If transported or stored at temperatures outside the operating temperature range, allow one hour for the UPS to
reach room temperature before use. There are no unusual risks associated with the proper disposal of this
equipment. Follow any local regulations regarding proper disposal of used electrical equipment.
Model # 200-006R
Universal Power Supply
1-
Hanger
2-
Volume LED Indicators
3-
Volume Control Buttons
4-
Footswitch Connector Receptacle and Indicator
5-
AC Connector Receptacle
6-
Power On LED Indicator
7-
On/Off Switch
8-
Cautery Instrument Connector Receptacle and indicator
9-
Power Level Control Buttons
10-
Power Level LED Indicators
Precautions And Warnings
• When used in the U.S. use only with supplied hospital grade power cord connected to hospital grade
receptacle.
• Use only with Microline Cautery Instruments and PowerPack Dual Control Footswitch. Use of any other
instrument may damage the instrument/UPS and could prevent it from functioning properly during use.
• Do not drop the UPS.
• Do not immerse the UPS in liquids.
• Do not sterilize the UPS.
• If using multiple Microline Cautery Instruments, do not allow instruments to contact each other. Do not
touch electrosurgical (Bovie) electrode to Microline Cautery Instruments.
• There are no user serviceable parts. Refer to "Universal Power Supply (UPS) Model 200-006R Service
Manual" 09-39-00454-00-ART for additional information.
• Use caution in hanging or placing the UPS on a surface prior to use. To isolate the UPS from supply mains
power, disconnect the power cord either from the bottom of the UPS or from the wall. Ensure access to
Storage
-15ºC to 35º
10 to 93
700hPa to 1060hPa
Operating
15ºC to 35º
30 to 93
700hPa to 1060hPa