Adjustments - Skil 3300MS Instrucciones De Funcionamiento Y Seguridad

SM_2610957116_05-08 6/5/08
BRACKET ADJUSTMENT SCREW
See Figure 10.
Mounting brackets are designed to fit snugly over the
stand rails. With the locking knobs are tightened to their
locked position, you should not be able to remove the
saw and bracket assembly from the rails. If the saw
and bracket assembly can be removed from the rails
when locked, the bracket adjustment screws need to
be tightened. If the saw and bracket assembly will not
fit over both rails, the bracket adjustment screws needs
to be loosened.
NOTE: The saw should be removed from the mounting
brackets before attempting to tighten or loosen the
bracket adjustment screws.
To adjust:
1. Use a wrench (1) to slightly loosen the nut (2).
2. Turn the screw (3) with a phillips screwdriver (4).
Rotate clockwise if the bracket assembly needs to
be tightened or counterclockwise if the assembly
needs to be loosened.
3. Install the bracket on the miter stand rails and
lower the locking lever to check the adjustment.
4. When the correct position is achieved, wrench
tighten the nut to secure.
5. Repeat with the second mounting bracket.
See Figure 11.
The stand is equipped with an adjustable foot for
leveling the stand.
To adjust: loosen wing nut (1) and adjust the height of
the foot (2) by screwing the threaded shaft clockwise to
raise foot or counter-clockwise to lower foot. Retighten
wing nut securely.
To reduce the risk of injury, insure the
!
WARNING
stand is stable and level before
operating the saw. Choose a level area to set-up the
stand and adjust the adjustable foot so that all four legs
are touching the ground.
7:44 AM Page 10

Adjustments

TO LEVEL STAND
2
3
FIG. 11
10
1
4
FIG. 10
1
2