Hilti RC 4/36-DAB Manual De Instrucciones página 21

All manuals and user guides at all-guides.com
Interference (noise) can occur when the radio is set to AM or FM frequency reception while a battery is being
charged.
4.3 Batteries
The appliance can be powered by the following Hilti batteries: B14, B18, B22, B36.
The appliance can charge the following Hilti batteries: B12 (only with adapter), B14, B18, B22, B36.
Note
Please note the approved batteries, as stated on the type identification plate.
The battery state of charge is shown continuously in the display. The battery symbol consists of 4 bars. Each
bar stands for 25%.
To protect the battery, the appliance switches itself off when the state of charge is too low. If this happens,
connect the appliance to the AC supply or change the battery.
The battery will be charged automatically when it is inserted in the charger and the charger is connected to
the AC supply. The battery symbol in the display indicates that charging is in progress.
If a battery is too hot or too cold when inserted into the charger, charging does not start until the battery
reaches its operating temperature.
Charging time and battery life depend on battery type, state of charge and battery temperature.
If the battery symbol does not appear in the display either the battery is not correctly inserted or the battery or
the appliance is defective. Stop using the appliance and the battery and have them checked by Hilti Service.
4.4 Information shown in the display
4.5 Cradle for external devices
Via Bluetooth or AUX, the appliance can play audio from external mobile devices such as mobiles/cellphones
or tablet computers. An external device can be cradled securely on the appliance.
Printed: 17.08.2016 | Doc-Nr: PUB / 5296507 / 000 / 00
The AM frequency band has been selected as the audio source.
The FM frequency band has been selected as the audio source.
DAB has been selected as the audio source.
Note
DAB offers the best audio quality, so select DAB as the audio source if it can
be received.
AUX has been selected as the audio source.
Indicates the battery state of charge. A bar stands for 25 %.
Indicates that the appliance is connected to the AC supply.
Bluetooth has been selected as the audio source.
If the pairing symbol flashes, the appliance is searching for a player with
which it can connect.
If the pairing symbol shows continuously, a player is connected via Bluetooth.
Indicates the bass settings.
Indicates the treble settings.
Indicates stereo playback. Stereo playback is activated automatically when
signal reception is good enough.
Indicates the station's memory slot.
Indicates the time.
Symbols flash in setup mode.
2
13