Black and Decker HELIX BL1600 Serie Manual De Uso Y Cuidado página 5

Note: Use PULSE for no more than five seconds at a time,
allowing the blender to rest briefly between each pulse, no
more than two minutes total. This helps break up the ice and
distribute the ingredients.
7. Open the lid cap to add ingredients while the blender is
running and drop ingredients through the opening (D).
• The lid cap holds up to 1 oz. liquid and can be used as a
measure when adding ingredients such as juices, milk,
cream and liquor (E).
• If air pockets or clogs form in the mixture, press down on
the lid to break them up. (F) This lowers the jar and raises
the blades within the mixture. (G)
Important: Do not remove the lid while the blender is running.
8. When finished, press the OFF button. Make sure blades
have completely stopped before attempting to remove
the blending jar from the base.
9. To remove the jar, grasp the handle, turn jar
counterclockwise and lift up.
Note: Always unplug the appliance when not in use.
USING THE SINGLE SERVE BLENDER JAR
(NOT INCLUDED WITH ALL MODELS)
Note: Do not blend hot liquids in the single serve jar.
1. Place the single serve blender jar on a flat surface with
the open end facing up. Fill the jar with ingredients. Do not fill ingredients
past the Max fill line.
Note: For best results, add ingredients in the following order:
1. Liquids 2. Powders 3. Soft foods 4. Hard foods 5. Ice
2. Place blade assembly in the jar opening with blades down.
3. Place jar base onto jar and rotate clockwise until it is tight. It is important
to tighten to prevent leaking during blending.
4. Turn single serve jar upside down and place on the blender base.
5. While blending, keep one hand holding the single serve jar. Select the
speed that best suits your desired task.
6. Once blending has finished, remove the single serve jar by lifting off the
base. Turn the jar over and place it on a flat surface.
Note: Always make sure blades have stopped moving before removing jar.
Important: If the jar gets stuck on the blending base or begins to loosen
from the jar base, follow these steps:
a. Unplug the unit
b. Turn the jar clockwise to tighten jar onto the jar base
7. Remove the jar base from the single serve jar by turning
counterclockwise. Then carefully remove blade assembly
8. Place the single serve jar drinking lid on the single serve jar and enjoy
your delicious drinks on-the-go.
Caution: Blades are sharp. Handle carefully.
D
E
F
G
5