Dimplex DF2690 Manual Del Propietário página 9

Fireplace Installation
Figure 2
Cable
Ties
5. Place the Front Glass onto
the track of the fireplace
(Figure 3) and slide it along
the front until it reaches the
far left of the unit.
6. re-attach the right hand
trim piece using the four (4)
Philips screws from step 4.
Fireplace Installation
Install the fireplace assembly
into the mantel (refer to mantel
assembly instructions).
!
NOTE 1: A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if after installation
Figure 3
Foam
Block
Front
Glass
Track
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
CAUTION: Clearance for
air circulation beneath the
fireplace insert is provided by
two spacers. Do not install
the fireplace insert directly
on carpet or similar surfaces
which may restrict air
circulation. If installing the
fireplace in a carpeted area,
place a one-piece, solid, flat
surface under the fireplace
insert. Ensure that all three of
the insert's feet rest securely
Trim
9