GE Baker Hughes Druck PV 212 Manual De Instrucciones página 7

2. Operation
WARNING
correct and equipment is internally clean and free from damage.
Make sure that all equipment is to the correct pressure rating.
Do not exceed the maximum operating pressure stated in the specification.
Observe the relevant health and safety precautions.
CAUTION
sufficient amount is used to achieve pressure seal. If excess tape is used,
particles can become loose during the connector mating process and enter
the pump, potentially leading to loss of pump performance or pressure
leaks.
Note: Wherever possible, use o-ring seals in the BSP connection ports this is the
recommended method of sealing.
Key to Figure #1
1. Pressure release valve.
2. Fine adjust vernier.
3. Prime/High pressure selector.
4. Scissor handles.
5. Reservoir.
6. Fluid inlet tube.
7. Reservoir fill plug.
8. Output port.
9. Output port.
10. Rear port for an optional pressure relief valve. Do not use for other functions.
11. Recommended fluid level.
2.1 Connecting the Pump
BSP ports can be fitted with any suitable length ¼ BSP male connector, sealing either with an
o-ring at the bottom of the port or a bonded seal at the top. Adaptors are supplied to convert
the BSP ports to ¼ NPT. Fit a suitable blanking plug to an unused port.
2.2 Pressure Release Valve (Figure #1)
Use this (1) to reduce or release the pressure in the system. The amount of turn sets the rate
to release the pressure. Only minimum force is necessary to seal the system.
© 2005 Baker Hughes, a GE company – All rights reserved.
All manuals and user guides at all-guides.com
Before applying pressure, make sure all connections are
If PTFE tape is used to seal NPT threads, ensure that only a
PV 212 Instruction Manual-English | 3