Publicidad
Idiomas disponibles
Idiomas disponibles
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the
reception is maybe affected by the following circumstances:
long transmitting distance
nearby mountains and valleys
near freeway, railway, airports, high voltage cable etc.
near construction site
among tall buildings
inside concrete buildings
near electrical appliances (computers, TV's, etc) and metallic structures
inside moving vehicles
Place the clock at a location with optimal signal, i.e. close to a window and away from metal surfaces
or electrical appliances.
Reception of the radio signal:
The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of
new fresh batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure with the
DCF signal to correct any deviations to the exact time. If this synchronization attempt is
unsuccessful (the radio mast icon disappears from the display), the system will automatically
attempt another synchronization at the next full one hour. This procedure is repeated automatically
up to total 5 times.
To manually start DCF signal reception, press the "WAVE" button once. If no signals received
within 7 minutes, then the DCF signal search stops (the radio mast icon disappears) and start
again at the next full one hour.
To stop searching radio signal, press the "WAVE" button once.
Notes:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as
televisions or computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
extreme circumstances, place the system close to the window.
During the DCF radio receive mode, only the "WAVE" button function, other button operation have
no function, If you want to carry out other functions of operation, please press "WAVE" button to
exit the DCF radio receive mode.
Selecting RCC mode on/off:
Hold the "WAVE" button until the beep tone sounds and "RCC OFF" is shortly displayed on the
LCD. The clock is now no longer using radio-controlled function.
Hold the "WAVE" button again until the beep tone sounds and "RCC ON" is shortly displayed on
the LCD. The clock is using radio-controlled function again.
12-hour or 24-hour time display setting:
Press the "DOWN" button to change the time displayed in 12-hour or 24-hour display.
Manual time setting:
Press and hold down the "SET/
OFF is displayed. Press the "UP" or "DOWN" button to set BEEP in ON or OFF.
" button for 2 seconds, the button BEEP sound settings: ON or
EN3
Publicidad
