Getting Started - Remixd ETRTWBBLK Manual De Usuario

English
USER GUIDE FOR REMIXD TRULY WIRELESS EARBUDS
ETRTWBBLK, ETRTWBRG,
ETRTWBBU, ETRTWBSV

GETTING STARTED

Charging the Case
1. Using the retractable charge cable included, plug the micro USB connector into
the case and the other end into a USB charger.
2. When charging, the case LED will blink red. When the case is fully charged the
light will remain solid red.
3. The case is also a mobile charging station giving you 4 charges on-the-go. When
charging the earbuds on-the-go the case LED will be a solid blue and
the earbuds will blink red.
4. Press silver button to begin charging. When the earbuds are fully
charged the light will turn off.
5. If the charge is fully depleted, you may need to re-pair the
earbuds to each other and then to your device after
charging. See section "Re-Pairing the Earbuds".
6. Earbuds will notify you with "low battery" when charging is
required while in use.
All manuals and user guides at all-guides.com
TO OPEN: PUSH IN COVER
THEN LIFT UP
Button Functions:
Power On: Hold both buttons for 3 seconds
Power Off: Hold both buttons for 8 seconds
Enter Pair Mode: Hold single button
for 8 seconds, starting with earbuds turned off
Summon Siri: Hold single button
for 2 seconds
Bluetooth® Pairing Instructions
NOTE: Your earbuds come pre-paired to one another. Power each on, wait for them to
recognize which is the left and which is the right sound channel, and then pair to your
device like any pair of Bluetooth earbuds. Should the earbuds become un-paired from
one another, see the section "Re-Pairing the Earbuds. "
Hold both earbud buttons for 2-3 seconds until both say "Power on. " Wait and you
should hear a pairing chime from both earbuds, then, "Pairing".
Now open up your Bluetooth setting on your device and pair to the "Remixd Truly
Wireless" device.
Your Truly Wireless Earbud Modes:
Powered Off: Earbuds are off and no light blink
Powered On Pairing: Earbud is on and blinks red and blue alternating. In pairing
mode your earbud is actively looking for all Bluetooth connections to phones and
other matching truly wireless earbuds. To enter pairing mode when powering on
the earbud, continue holding the button past the power on prompt for ~8 seconds
until the 'pairing' prompt plays. This is how to pair only one earbud or unpair the set.
Powered on searching: Earbud is on and blinks a slow blue. In searching mode your
earbud becomes the host connection and seeks out its partner earbud. To enter
searching mode, power on the earbud and double tap the button. You should hear
a 'searching for earbud' prompt. This is how to re-pair the set.
Pause/play: Single press
Skip track: Double press
Answer/end call: Single Press during call
Reject call: Hold button for 3 seconds
during call
1