CAME ZBK8 Manual Del Usuario página 9

Memorizing the code on the command board
- Connect the antenna with the RG58 cable to the apposite terminals on the board
- The AF1 board must ALWAYS be inserted into the coupling
is powered.
- Keep the "CH1" key pressed on the base card, the signal LED
- Press a transmitter key to send the code; the LED
N.B.: if the code needs to be changed, repeat the sequence described above.
Installation procedure for the remote control for automatically releasing the motor (pratico system)
- Disconnect the 230V power and insert the AF2 radio card (with the same frequency used for AF1 card) in the slot
recognises it only when it is battery powered.
- Insert the terminal (-, +) connected to the battery to the free coupling of the motherboard
Note: the board must be battery-powered for saving procedures. Check the LED signalling 230V
i
- Keep the key on the basic board depressed. The signalling LED
- Press a key (the same one memorized for opening the gate) on the transmitter to send the code. The LED
successful memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
d
when the power is off because the motherboard only recognises it when it
e
will fl ash.
e
will remain lighted to signal memorization.
j
fl ashes (intermittent LED).
c
.
g
.
h power is off.
j
will remain lighted to signal
, the motherboard
f
9