Uline H-7618 Guia De Inicio Rapido página 2

CLAMP MOUNTING
1
M6 x 20 mm Bolt
4 x 4 Allen
Wrench
Clamp Mounting
Bracket
NOTE: Clamp mount is compatible with desk
thickness of 3/4 – 3⁄".
1. Attach clamp mounting bracket (5) to bottom of
tube (4) using M6 x 20 mm bolts (C) and 4 x 4 Allen
wrench (F). (See Figure 2)
NOTE: Opening near bottom of tube is for cable
management. Make sure opening is aligned
with back of clamp mounting bracket.
GROMMET MOUNTING
1
Tube
M6 x 20 mm Bolt
NOTE: For grommet mounting, hole in desk
must be 3/8 – 2¾".
NOTE: Grommet mount is compatible with desk
thickness of 1 – 3½".
1. Attach grommet mounting plate (8) to bottom of
tube (4) using M6 x 20 mm bolts (C) and 4 x 4 Allen
wrench (F). (See Figure 3)
NOTE: Opening near bottom of tube is for cable
management. Make sure opening is aligned
with indent on grommet mounting plate.
PAGE 2 OF 12
2
Mounting
Holes
2
Grommet
Mounting Plate
4 x 4 Allen
Wrench
Grommet
Bolt
ASSEMBLY
Anti-Slip Foam
M6 x 10 mm Bolt
4 x 4 Allen
Wrench
Clamp
2. Apply anti-slip foam (6) to ring on clamp (7). Select
the appropriate mounting holes based on the
thickness of the desk. Attach clamp (7) to the clamp
mounting bracket (5) using M6 x 10 mm bolts (D)
and 4 x 4 Allen wrench (F).
3. Place clamp mounting bracket and clamp over
desk and fully tighten knob.
Desk
Bottom
Support
2. Thread grommet bolt (10) through bottom support (9).
Insert bolt into hole of desk and into center hole in
grommet mounting plate (8).
3. Fully tighten grommet bolt (10) using 6 x 6 Allen
wrench.
3
Tighten
3
Tighten
6 x 6 Allen
Wrench
Desk
Figure 2
Figure 3
0521 IH-7618