Mounting The Monitor; Vertical/Horizontal Mounting; Console Top Mounting; Overload Indicator - Phonic P5A Manual Del Usuario

MOUNTING THE MONITOR

VERTICAL / HORIZONTAL MOUNTING
The speakers are normally delivered for vertical
dio monitor requires shorter distance than traditional
monitors from its location to your ears, which means
the reverberation time and general acoustics of the
listening room are less critical. Hard surfaces will,
to avoid putting this monitor close to side walls. The
control surface of your mixing console may also pose
using the meter bridge or rear panel to block sound
from both drivers reaching the control surface. Make
sure that there is nothing between your ears and the
speakers. If your console has no meter bridge, try
positioning the monitor higher or further behind the
desk. Active series is designed to be used in both the
upright and horizontal position. If you want to place
two Active series horizontally, it is recommended you
put the HF drivers on the outer edge. The low fre-
quencies of this unit will generally sound better if the
cabinet is against a wall. If possible, provide a rigid
surface (eg.shelf) that is separate from the mixing
console and other equipment. The speakers should
roughly form a 60 degree angle at the listening posi-
tion, and should be angled towards the listener(s).
P5A / P6A / P8A
All manuals and user guides at all-guides.com
-

CONSOLE TOP MOUNTING

If the active studio monitor series are used for console
top mounting, it is recommended not to mount the
speakers directly on the console; instead, position
the speaker slightly behind the console by using
coloring the sound.

OVERLOAD INDICATOR

The speaker is provided with one bi-colored indica-
tor on the bottom right corner of the horn. When lit
in green, it indicates that the speaker is ready for
use. The indicator lighting up in red means that the
is activated. In either cases, reduce the signal level
so that the red LED stops blinking. If the red indica-
cool down and check that the ventilation at the rear
side of the speaker is not blocked. There should be
a clearance of more than 4 inches (10cm) between
speaker rear and any solid surface.
7