Rear Panel - Phonic PCR2213 PLUS Manual Del Usuario

28 27 26

4.2 REAR PANEL

Just like the front panel, the text above the input/output sockets
are STEREO mode and the text below the sockets are MONO
mode. They are clearly marked to minimize mistakes.
19. IN 1 / IN 2
The input sockets are standard XLR female type. Set in the
signal to IN 1 in MONO mode. The IN 2 socket is not effective in
MONO mode.
Φ
20.
These are phase invert buttons, the phase will be inverted as soon
as the button is pressed.
21. LOW 1 / LOW 2
These are the LOW outputs. In MONO mode, they become LOW
and MID output.
22. HIGH 1 / HIGH 2
These are the HIGH outputs. In MONO mode, HIGH 1 is not in
used. HIGH 2 is the HIGH output.
23. Sub Output
This output will always output the summed output signal from
the low 1 and low 2 channels when in stereo mode or the low
frequency signal when in mono. The purpose of this output is to
provide additional low-end output to subwoofers.
10
All manuals and user guides at all-guides.com
25 24 23 22
Σ
24. SUB
When set this switch to the ON position, the subwoofer output
will be activated. It will be disengaged when users switch to the
OFF position.
25. STEREO/MONO
Slide to top for STEREO 2-way mode, and slide down for MONO
3-way mode.
26. POWER SW.
To turn the unit on and off. This switch is best located in the rear
panel to avoid accidental tampered during operation which en-
danger the whole speaker system.
27. POWER SOCKET
Standard IEC socket for power connection. Check the voltage
before connection.
28. GROUND POINT
Chassis grounding point for properly grounding.
21 20 1
PCR2213