Maintenance; Changing The Saw Blade - Greencut SRJ200L Manual De Instrucciones

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the machine is completely turned off before performing any maintenance
or repairs. This will eliminate any potential risks.
ATTENTION: Clean the machine after each use to prevent the build-up of sawdust and wood resin
on the machine components, table and saw blade. Use a suitable cleaning agent to remove the
wood resin.
LUBRICATION
• Regularly clean and lightly grease the angular mechanism of the table.
• Regularly lubricate the blade tension adjuster and the threads of the roller tilt adjustment screws.

CHANGING THE SAW BLADE

1. Turn the blade tension regulator (A) to the left (counterclockwise) until there is no blade tension.
2. Open the upper door (B) and lower door (C) of the machine by unscrewing the door knobs.
3. Carefully pull the roller blade (D) out of the machine through the slot (E) on the table.
4. Carefully insert the new knife into the machine through the slot in the table and place it on the rollers.
5. Turn the blade tension adjuster clockwise until you feel the blade begin to tighten. Make sure the blade teeth
are facing outward and pointing downward through the blade guide.
6. Adjust the tension and alignment of the saw blade.
55
EN