Humanscale M/Connect 2 Guia Del Usuario página 9

Bolt-Through Mount
Installing on a work surface with no clamp system
1
Drill half inch hole in desired location
2
To ensure M/Connect makes full contact with desk, locate hole at least two inches from back edge of desk
3
Lower M/Connect onto desk aligning bolt with hole
4
Slide the bolt-through plate (fig. I) over the bolt and tighten the nut , ensuring a secure fit
5
Place the protective plastic cap onto bottom of the bolt (fig. J)
①
½ inch hole
Connecting Cables To M/Connect
Plug in power cable
1
Insert power cable (fig. N) into rearward power jack
2
LED light (fig. O) will illuminate to indicate power
CAUTION: The 60W M/Connect 2 requires the 150W power supply. The 100W M/Connect 2 requires the 180W power
supply. Attaching the 150W power supply to the 100W M/Connect 2 will cause the unit to turn off.
④
N
②
I
⑤
③
J
O
9