Safety Guidelines; Technical Data; Options; Assembly - resideo Braukmann F70C Instrucciones De Instalación

1

Safety Guidelines

1. Follow the installation instructions.
2. Use the appliance
• according to its intended use
• in good condition
• with due regard to safety and risk of danger.
3. Note that the appliance is exclusively for use in the
applications detailed in these installation instructions
(see 2 Technical Data). Any other use will not be
considered to comply with requirements and would
invalidate the warranty.
4. Please take note that any assembly, commissioning,
servicing and adjustment work may only be carried
out by authorized persons.
5. Immediately rectify any malfunctions which may
influence safety.
2

Technical Data

Media
Medium:
Connections/Sizes
Connection sizes:
Pressure values
Max. operating pressure:
Operating temperatures
Max. operating temperature
medium accord. to EN 1567:
Specifications
Installation position:
Note: The filter is constructed for drinking water installations. In
case of a process water application the filter has to be
proven individually.
3

Options

For Options visit homecomfort.resideo.com/europe
4

Assembly

When connecting to an existing flange of another make (e.g.
Cillit) ensure that the inlet flow is through the outer ring of
holes. If this is no so, the whole connection piece must be
installed the other way round, even if the arrow does not the
indicate the actual flow direction. If the flange is threaded, the
threaded holes must be drilled out to a diameter of 6.3 mm.
Drinking water
3 1
/ " - 1 / "
4 4
16.0 bar
30 °C
Horizontal or vertical, with
filter bowl downwards
GB
4.1 Installation Guidelines
• Install in horizontal or vertical pipework with filter bowl
downwards
– This position ensures optimum filter efficiency
• Install shut-off valves
• These filters are armatures which need to be
maintained regularly
• Ensure good access
– Pressure gauge can be read off easily
– Degree of contamination can be easily seen with
clear filter bowl
– Simplifies maintenance and inspection
• The installation location should be protected against
frost
• Related to the EN 806-2 it is recommended to install
the filter immediately after the water meter
• In order to avoid flooding, it is recommended to
arrange a permanent, professionally dimensioned
wastewater connection
5

Maintenance

In order to comply with EN 806-5, water fixtures must
be inspected and serviced on an annual basis.
As all maintenance work must be carried out by an
installation company, it is recommended that a
servicing contract should be taken out.
If necessary, the outside surface of the filter can be cleaned.
Use only cold, clear drinking water to clean the surfaces! Any
other cleansers cause damage to the plastic components!
The frequency of replacement of the filter insert depends on
local conditions and the character of the water. However, for
hygenic reasons, this service is to be accomplished at least
every six month.
6

Disposal

Observe the local requirements regarding correct waste
recycling/disposal!
7

Spare Parts

For Spare Parts visit homecomfort.resideo.com/europe
8

Accessories

For Accessories visit homecomfort.resideo.com/europe
2 MU1H-1147GE23 R0220