Getting Started With The Scale - ADE M320000-01 Instrucciones De Uso

 Carefully unpack the scale and accessories and remove all packaging materials.
 Remove both M12 cheese head screws from the column.
 The cable has a band at both ends.
 Insert the cable end and the smaller plug of the band in the opposite direction of the arrow
through the column.
 Connect the small plug to the scale platform.
 Do not pull the scale platform by the plug. Insert it as far as possible in the inside of the scale
platform.
 Place the column on the support of the scale platform.
 Place the scale on its side.
 Screw the scale platform and the column using the M12 cheese head screw provided for this
purpose.
 Set up the scale.
 Mount the mounting plate to the end of the column marked by the arrow (indicator side). Make
sure that the positioning aids point to the column.
 Screw the mounting plate and the column using the M12 cheese head screw provided for this
purpose.
 Connect the free end of the cable to the indicator. Use the band to pull the cable end through
the mounting plate, if necessary.
 Place the indicator on the mounting plate. Screw the mounting plate and the indicator using
the two M6 cheese head screws provided for this purpose.
 Insert the 4 supplied 1.5V AA batteries in the battery compartment. When inserting the
batteries, pay attention to the correct polarity (as shown in the battery compartment) and that
the insulation of the batteries is undamaged.
 For mains operation, connect the supplied mains adapter to the mains connection.
 Place the scale on a level, stable surface.
 Align the scale using the support feet. Make sure that the air bubble of the spirit level is
centred in the black frame.
 Use the main switch to switch on the scale. After the warm-up time (15 minutes), the scale is
ready for use.
Check the horizontal position of the scale after every
change of location!
Page 30 of 24

5. Getting started with the scale

M320000-01+02-210429-Rev004-UM-en