Bmi Function; Beep; Bluetooth - ADE M320000-01 Instrucciones De Uso

on it without taking the additional weight into account. You can now use the scale as often as you
wish; the saved value will always be deducted as long as the scale is not switched off.
Press the Tare key again to exit the tare function.
7.8

BMI function

The body mass index is the ratio between the body mass and height. The BMI is a globally
accepted index - also by WHO (World Health Organization) - and helps assess both the nutritional
and health status of a person. The result is a tolerance value.
Calculation of the BMI value:
Compare the specific value with those used by WHO.
To determine the body mass index, you need the body height of the person to be weighed.
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display. Briefly press the BMI key. Set the body height of the person to be weighed in cm. The
indication will appear blinking at the upper right-hand corner of the display. Briefly press the BMI
key to increase the value. Briefly press the ON/OFF key to decrease the value. Briefly press the
HOLD key to enter. Now begin the weighing process. The display will start to blink at standstill. You
can now unload the balance. The BMI value can be read off at the upper left-hand corner of the
display. Press the Tare key to exit the BMI mode.
7.9

Beep

NOTE: The beep tone is deactivated by default. If desired, you can activate the function.
Please ask for the extended instructions.
If activated, a beep sounds when ...
... the scale is overloaded.
... the scale is underloaded.
... a key is pressed.

7.10 Bluetooth

NOTE: The (optional) Bluetooth module is disabled at the factory.
Information on activating and setting up the Bluetooth interface as well as pairing
with other devices will only be announced once Bluetooth devices approved by
ADE are available.
M320000-01+02-210429-Rev004-UM-en
=
( ℎ ℎ )
Page 33 of 120