Publicidad
Idiomas disponibles
Idiomas disponibles
USE EXTREME FORCE WHEN TIGHTENING THE LEVER IN STEP 14. TEST THE INSTALLATION!
Assemble Pod and Skewer:
STEP
Assemble the
two halves of
the pod loosely
onto the
crossbar.
Single screw hole indicates FRONT.
Attach the
pod cover.
Assemble Wheel Tray.
Compress the
strap into the red
button slots.
All manuals and user guides at all-guides.com
LoadWarrior
users:
Attach the tube
sleeve onto the
crossbar.
Insert the skewer while
applying pressure to
the pod cover.
Pod cover must
be in place at all
times for safe
operation of bike
carrier.
Insert the carriage
bolt vertically into
the lower hole.
Position the pod
so that the front
dips slightly.
FRONT
(side view)
Skewer direction is your choice;
consider lock access.
SQUARE BARS
ONLY:
The angled hole is for very
short or very wide crossbar
distances.
Tighten the screws using the
supplied hex wrench.
The pod must not rotate!
Tighten until
there is no longer
a gap between
the pod halves.
Attach the
skewer nut.
Leave plenty of
skewer showing.
Attach SnapAround
If you have square
bars, see last page for
SnapAround Instructions.
Publicidad
