Adjusting Bun Crush Settings; Adjusting For Bun Thickness - Prince Castle McDonald's 247 Serie Operación Manual

Toaster Grills
Models 247 & 248
To adjust the bun crush settings, use the knob located on the
front of the unit's base. There are 10 incremental settings, each
increasing the center gap by approximately 2 mm.
(See Figure 17.)
• To set the thickness from 1 to 5, lift and slide the knob to the
left-most position. Then, rotate the knob until the desired
setting is in the "window".
• To set the thickness from 6 to 10, lift and slide the knob to the
right-most position. Then, rotate the knob, until the desired
setting is in the "window".
The 248 model has two sets of notches in the side bun fences.
(See Figure 18.)
• Put the bun board in the front, lower notches for REG or QTR
buns.
• Use the rear, upper notches for MAC or RIB buns.
Printed in USA 01/05 © 2005
All manuals and user guides at all-guides.com

Adjusting Bun Crush Settings

Figure 17

Adjusting for Bun Thickness

Figure 18
12 247-500E