Bosch Professional GCM 10 SD Manual Original página 49

Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer Horizontal mitre
corner angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Bosch Power Tools
In addition, the cut can be perfomed with or
without slide movement depending on the
width of the profile strip/moulding.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Placed
against
the fence
0°
Left side Right side
45° left 45° right
Bottom edge Bottom edge
on saw table on saw table
... to the left of ... to the right
the cut of the cut
45° right
Bottom edge Bottom edge
on saw table on saw table
... to the right ... to the left of
of the cut
Lying flat
on the
saw table
Left side
0°
Upper edge
against the
fence
... to the left of
the cut
45° left 0°
Bottom edge
against the
fence
... to the right
the cut of the cut
English | 49
45°
Right side
0°
Bottom edge
against the
fence
... to the left of
the cut
0°
Upper edge
against the
fence
... to the right
of the cut
1 609 929 X04 | (13/7/10)