System Settings - Orlaco UM0206600 V2.2 Manual De Instrucciones

System settings

Delay activation
Remark: If one camera is controlled by an inter-
mittent signal (e.g. from an indicator light), the
delay must be activated to prevent the picture
from flickering. Factory settings: Camera 1 and 2
delay on, camera 3 delay off. The delay cannot
be activated if the respective camera is already
control led via an intermittent signal.
Select the respective camera with button 1
Activate the delay by holding button 3
for 40 seconds (The LED for the on/off button will
flash 1x). Repeat this operation to deactivate the
delay.
Mirror image activation
Select the respective camera with button 1
Activate the mirror image by holding buttons
1 and 3
seconds (the LED for the on/off button will flash
1x). Repeat this procedure to deactivate the mirror
image.
Inverted image
Hold buttons 1
time for 40 seconds to activate inverted image.
Remark: If inverted image is activated, the picture
from the camera is shown upside down on the
monitor.
Marker on/off
Hold buttons 2
time for 10 seconds to switch the marker on and
off. Set the marker to the required position with
button 6 or button 7
Monitor 50/60Hz
Hold button 4
the monitor to 50 Hz or 60Hz.
Remark: This setting is only necessary in combi-
nation with a navigation system.
Switch off the keyboard
Hold buttons 1
time for 15 seconds to switch off the keyboard.
Remark: If the keyboard is switched off, the
monitor is continuously switched on and further
operations are not possible.
UM0206600 V2.2
pressed in at the same time for 20
and 2 pressed at the same
and 3 pressed at the same
.
pressed for 60 seconds to set
and 5 pressed at the same
Usermanual
Manual Camera selection On/ Off
Hold buttons 1
time for 40 seconds to switch on/ off the manual
camera selection mode.
Remark: The user has for example the choice to
overrule manually by pressing button 1
some cases this is however not suitable, such as
priority on security cameras. For this reason, it is
possible to switch off the manual camera selection
mode.
Warning: by switching off the manual cam.selec-
tion mode the control wire has always priority.
.
pressed
Cinema/wide
Hold the button 5
switch to wide screen cinema.
LED indication
If the LED for button 1
.
and 8 (monitor on/powersave) flash together
quickly, the image is switched off as the ambient
temperature is below -40°C or above +75°C. At
temperatures below -25°C the monitor does not
start anymore.
Objec t s in
C3
monitor are
C2
closer than
they appear
C1
Buttons
Button no 1 = Camera selection
Button no 2 = Automatic brightness on/off
Button no 3 = Standby function on/off
Button no 4 = Contrast
Button no 5 = Brightness
Button no 6 = Adjustment -
Button no 7 = Adjustment +
Button no 8 = On/power save
and 4 pressed at the same
pressed for 60 seconds to
(camera selection)
1 2 3 4 5
. In
6 7 8
4