Black and Decker JU350S Manual De Instrucciones página 16

ENGLISH
Never carry the inflator by the hose.
This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they
do not play with the appliance.
ADDITIONAL SAFETY INSTRUCTIONS
FOR BATTERIES AND CHARGERS
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C
and 40 °C.
Charge only using the charger provided with the
appliance/tool.
When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture
or impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
-
In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse immediately
with clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the appliance/tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
All manuals and user guides at all-guides.com
FEATURES
1. LED area light
2. Heavy-duty copper clamps
3. LED area light on/off switch
4. Reverse polarity indicator
7. ON/OFF switch
8. Carry handle
9. Battery status pushbutton
10. Battery status LEDs
11. 12Vdc charging socket
10. USB Power On Indicator
11. USB Power Port
12. USB On/Off Switch
13. Inflator On/Off Switch (JU450CB)
14. Air Hose with Universal Valve Adaptor (JU450CB)
15. Pressure Gauge (JU450CB)
16. Accessory Storage (JU450CB)
USE
Charging the unit
This unit is shipped in a partially charged state.
Lead-acid batteries require routine maintenance to ensure a
full charge and a long battery life. All batteries lose energy
from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, Black & Decker
recommend that the battery is charged at least every
60 days.
Note: Charging the battery after each use will prolong the
battery life; frequent heavy discharges between charges
and/or overcharging will reduce battery life.
The battery can be charged using the charging adaptor.
Charging the unit with the main charger
Make sure that the ON/OFF switch (5) and the LED area light
(1) are turned off while the unit is being charged.
As charging progresses, the red LEDs will light one by one.
Note: The mains charging should not be connected for more
than 60 hours.
16
Do not probe the charger.
The appliance/tool/battery must be placed in a well ventilated
area when charging.
Charge the unit before first use using the charging adaptor
for 48 hours.
Check the battery charge level by pressing the battery
status pushbutton (7). The LED charge status display
(8) will indicate the level of battery charge. When only
one red LED lights, charge the unit.
Insert the jack plug of the charging adaptor into the
charging socket (9).
Insert the charging adaptor into a power socket.
Charge the unit until the green FULL LED lights.
Continue to charge for one to two more hours.