Troubleshooting; Technical Data; Information On Vibration Reduction; Information On Noise Reduction - monzana DBET001 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
with or even immersed in liquids. Regular maintenance helps to ensure the safety of the product
and increases its service life.

8.0 TROUBLESHOOTING

problem
The tacker does not work
(Note: The tacker only
works when the tacker is
attached and pressure is
applied to the locking
pin).

9.0 TECHNICAL DATA

Item no.
102955
Model
DBET001
U
220-240V~50Hz
P
45W
Protection class
II
Shots/min
30

9.1 INFORMATION ON VIBRATION REDUCTION

The indicated vibration emission value complies with EN 60745-2-16. The actual existing vibration
emission value during the use of the machine may differ from the value indicated in the operating
instructions or by the manufacturer. This can be caused by the following influential factors, which
should be taken into account before or during use:
Is the machine used correctly?
Is the machine in good working condition?
If you notice an unpleasant feeling or skin discoloration on your hands while using the machine,
stop working immediately. Take sufficient breaks from work. Failure to take adequate breaks may
result in hand-arm vibration syndrome.
The degree of stress should be estimated depending on the work or use of the machine and
appropriate breaks should be taken. In this way, the degree of stress can be significantly reduced
during the entire working time. Minimize the risk to which you are exposed in case of vibrations.
Maintenance of this machine must be carried out in accordance with the instructions in the
operating manual. Avoid using the machine at temperatures of t=10°C or less. Make a work plan
which limits the vibration exposure.

9.2 INFORMATION ON NOISE REDUCTION

There is some noise exposure to this machine that cannot be avoided. Reschedule noisy work to
approved and designated times. If necessary, observe rest periods and limit the duration of work
solution
Lock the tacker (lock-on position).
Pull out the power plug
Open the cartridge holder by pulling the reloading
lever and letting the stuck nails/staples fall out.
Reload the tacker.
Test the tacker on something to be trashed.
18
Nails type
15 mm
Staples type
6-14 mm
Lpa
73.8 +3 dB(A)
Lwa
84.8 + 3 dB(A)
Vibration value
4.678+1,5 m/s2
www.DEUBAXXL.de

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

102955

Tabla de contenido