Kunft KC3904 WH Manual De Instrucciones página 21

Problem
The
appliance
does not
work
The food is
too warm
The
appliance
cools too
much
unusual
noises
There is
water on
the floor
The side
panel is hot
If the malfunction shows again, please contact the Service Centre.
Frigo-KC3904-Manual-2.indd 21
refrigerator combi
Possible cause
The temperature
regulation knob is set at
number "0".
The power plug is not
plugged in or is loose.
a fuse has blown or is
defective.
The socket is defective.
The temperature is not
properly adjusted.
The door was open for
an extended period.
a large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near
a heat source.
The temperature is set
too cold.
The appliance is not
levelled.
The appliance is touching
the wall or other objects.
a component, e.g.
a pipe, on the back of
the appliance is touching
another part of the
appliance or the wall.
The water drain hole
is blocked.
The condenser is inside
the panel.
KC3904 WH
Solution
Set the knob at other
number to switch
on the appliance.
Insert the power plug.
check the fuse, and
replace it if necessary.
any mains malfunctions
are to be corrected by
an electrician.
Please refer to the initial
Temperature Setting
section.
open the door only when
needed.
Temporarily turn the
temperature regulation
to a colder setting.
Please refer to the
installation location
section.
Temporarily turn the
temperature regulation
knob to a warmer setting.
re-adjust the feet.
Slightly move
the appliance.
If necessary, carefully
bend the component
out of the way.
refer to the cleaning
section.
This is normal.
21
EN
18/02/02 16:39