Environmental Protection - Worx WX622 Manual Del Usuario

of the dust bag.
NOTE: This accessory can be used for
smaller jobs.
9. EXTERNAL DUST EXTRACTION
The dust extraction (5) is best connected to a
suitable external dust extraction machine e.g.
vacuum cleaner.
WORKING HINTS FOR YOUR
PLANER
WARNING: Danger of kickback! Apply
the machine to the work piece only
when switched on.
1. STANDARD SURFACE PLANING
Set the desired cutting depth. Position the
front part of the base plate flat onto the work
surface. Switch the machine on and push your
planer forward and it will start cutting, always
maintain all of the base plate flat on the work
surface to prevent the cutting blade jumping.
Move the plane evenly over the work surface.
10 10 For most applications 0-3mm max cutting
depth will produce a good surface finish. It is
best to use small depths of cut and repeat the
planing process.
2. EDGE CHAMFERING
Using the V-groove in the base plate (15) you
can make a chamfer on the work piece edge
(See Fig H). Guide the planer along the edge
and maintain a constant angle and force to
produce a good finish.You can control the
angle of the chamfer with your hands. Make a
test chamfer on a scrap piece of wood. Ensure
your work piece is clamped and supported
near the edge.
3. REBATING (SEE FIG I, J, K)
You use the Rebate Depth Gauge (16) and
the Rebate Parallel Guide (17) accessories
(supplied with your tool). Fit these accessories
to your planer.
Set the required rebate depth using the scale
and the mark on the planer housing next to
the scale.
Set the required rebate width stop on the
Planer
All manuals and user guides at all-guides.com
parallel guide (17) using the locking screw and
adjust the required rebating width (max 82
mm).Tighten locking screw.
Set the parallel guide (17) using the locking
screw on the planner housing.
Adjust the desired rebating depth with the
rebating depth gauge (16) accordingly (max
24mm) .Plane as often as necessary to achieve
the desired rebating depth. Make sure the
plane is guided with a lateral supporting
pressure.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
EN