Turboair DIGITA Montaje Y Modo De Empleo página 18

WARNING!
Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
Operation
1 = ON/OFF – Speed increase
2 = Lights ON/OFF
3 = Selection of the desired function
4 = Setting the function in use
5 = The display shows:
a – list of available functions
b – indicator of the function currently in use
c – indicator of the speed in use
d – clock / data related to the function in use
e – saturation of the anti-grease filter
f – saturation of the carbon anti-odour filter
Available functions
SPEED
Switch on/Speed increase:
- press button 1 to switch on the hood
- press button 1 to go to the next speeds, until the hood is
switched off
The extraction speed is shown on the display (c), in the
following manner:
1st
speed
2nd
speed
3rd
speed
high
speed
OFF
performance
40% ***
performance
60% ***
performance
80% ***
performance
100% ***
*** the percentage displayed refers to the indicative value of
the performance
The high speed is timed for 10 minutes; to interrupt the timing
and switch off the hood press button 1.
NB= the speed might increase automatically during use, this
is because the control is fitted with a system that protects the
display in case of overtemperatures.
CLOCK
To set the clock:
- press button 3 until moving the indicator(b) on function
"CLOCK"
- press button 4 to access clock setting
- keep button 4 pressed:
• keeping it pressed for one second increases the time by
one minute
• after 10 seconds, each second it is pressed increases the
time by 10 minutes
To store the set time:
- press button 3
TIMER
Stopwatch Function
- press button 3 until moving the indicator(b) on the "TIMER"
function
- press button 4 to access timer setting
- to start the stopwatch: simultaneously press button 3 and
button 4, for 5 seconds
- to stop the stopwatch: simultaneously press button 3 and
button 4, for 5 seconds
Note= after 60 minutes the stopwatch stops automatically
"Countdown" Function
- press button 3 until moving the indicator(b) on the "TIMER"
function
- press button 4 to access timer setting
To set the "Countdown" timer:
- keep button 4 pressed:
• keeping it pressed for one second increases the timer by
one minute
• after 10 seconds, each second it is pressed increases the
timer by 5 minutes
To save the "Countdown" timer
- press button 3
The Timer indicator(b) will start flashing to indicate the
start of the "Countdown"
When the "Countdown" reaches "0:00" the motor is
switched off
Note = to set a new timer, button 4 must be pressed until the
indication "0:00" is displayed again
Note = the maximum countdown setting time is 60 minutes
18