Getting Started; When Using The Remote Control; Remote Control Battery Replacement; Overhead Monitor - Alpine TMX-310U Manual Del Usuario

Getting Started

When Using the Remote Control

• Point the remote control at the remote sensor within
about 2 meters.
• It may not be possible to operate the remote control
if the remote control sensor is exposed to direct
sunlight.
• The remote control is a small, lightweight precision
device. To avoid damage, short battery life,
operational errors and poor response, observe the
following.
- Do not subject the remote control to excessive
shock.
- Do not put in a trouser pocket.
- Keep away from food, moisture and dirt.
- Do not place in direct sunshine.
When you use Remote Control for the first time, pull the plastic tape
before using the remote control.

Remote Control Battery Replacement

Battery type: CR2025 (3V) battery or equivalent.
1
Opening the battery case
Pull up the battery cover while pressing in the direction of
the arrow.
2
Replacing the battery
Put the battery in the case with the (+) indication upward
as indicated on the remote control housing.
• Placing a battery in backwards way may cause a
malfunction.
3
Closing the cover
Slide the cover until a click is heard.
Warning
DO NOT OPERATE ANY FUNCTION THAT TAKES
YOUR ATTENTION AWAY FROM SAFELY DRIVING
YOUR VEHICLE.
Any function that requires your prolonged attention should
only be performed after coming to a complete stop. Always
stop the vehicle in a safe location before performing these
functions. Failure to do so may result in an accident.
4
-EN

Overhead Monitor

LCD Monitor Panel
This is a 10.2 inch, Wide VGA, Active Matrix LCD. In addition, an
Infrared Wireless Headphone Transmitter is located on top of the
LCD panel.
Monitor Open Button
Press Monitor Open Button to release the Monitor Panel. The Panel
will drop down slightly allowing you to fully open to its 90 degree or
greater position. To close, firmly press the LCD Monitor Panel back
up into the housing until a click is heard.
White LED Dome Light
White LED Dome Light connection has polarity. Be cautious when
installing the monitor.
Dome Light Switch
Dome light switch turns on/off the dome light. When the switch is
set to DOOR, the dome light turns on when the door is open.
Front Control Keys
Blue, back-lit buttons illuminate when the overhead monitor is turned
on. POWER Button: switch the monitor on/off. SOURCE Button:
switch the sources (Media Player, AUX1, AUX2).
IR Transmitter and Receiver
IR transmitter sends the sound to the Headphone. IR receiver
receives the signal from the remote control.
Remote Sensor / IR
Transmitter
DOME LIGHT
SWITCH Button
POWER Button
Monitor OPEN Button
SOURCE Button
SD card slot and
External USB port
LCD Monitor Panel
AUX1 IN, AUX2 IN
AUX OUT and POWER
Harness
Internal USB port
Game port