Blackview X2 Manual Del Usuario página 6

Introduction To the Connection between Watch and Mobile Phone
1. Download and install APP (H Band)
Scan the QR code on the box or the built-in QR code on the watch via the mobile browser
program to download. Downloading needs WIFI network or data traffic. Install it after
downloading, open the APP after the installation, and give the software corresponding rights
which are needed for Bluetooth connection. (Note: H Band supports IOS9.0 or later and
Android6.0 or later)
(H Band QR Code)
2. The way to connect the watch to the phone (same for iOS and Android)
Turn on the Bluetooth of the mobile phone, and then open the H Band application on the mobile
phone desktop (Figure 1). You can choose to log in without an account or log in with a registered
account. On the device search page, allow H Band to use Bluetooth permissions. Click "Scanning
equipment" to search for devices (Figure 2), (Figure 3) Select the corresponding device (X2) and
click to connect. After a few seconds, it will prompt a Bluetooth pairing request between the
watch and the phone (ios need to be paired, Android does not need), please allow "Bluetooth
pairing" to complete the phone and watch After the connection is successful, you will be
prompted whether you need to upload data to the cloud (Figure 4). This operation can be selected
by yourself. Clicking NO or YES will connect successfully. At the same time, you need to set the
application switch for push notifications. You can check it according to your needs. Will the
system on ios 13 or above pop up the "Allow" X2" notification to display "iphone"? Click
"Allow", and then allow you to click "Confirm" to enter the homepage (Figure 5). (Note: The
sync data function will automatically upload once every 30 minutes)
4