Sony AIWA CSD-MP100 Instrucciones De Manejo página 15

Tape player
The player does not move when you press an
operation button.
• Close the cassette compartment securely.
The w REC does not function.
• Make sure the cassette tab for the side is not broken
(see page 13).
The player does not erase completely.
• Clean the erasing head (see page 13).
• Replace all the batteries with new ones if they are
weak.
• The source which was recorded on TYPE II (high
position) or TYPE IV (metal) tape by this unit is being
played. Record on TYPE I (normal) tape and play.
The player does not record.
• Make sure the tape is inserted properly.
• Make sure the cassette tab for the side is not broken
(see page 13).
The audio is weak/The audio quality is poor.
• Clean the heads, pinch roller and capstan.
• Demagnetize the heads using a demagnetizer.
The sound is distorted.
• TYPE II (high position) or TYPE IV (metal) tape is
being used. Use TYPE I (normal) tape only.
Remote control
The remote does not function.
• Replace all the batteries in the remote with new ones
if they are weak.
• Make sure that you are pointing the remote at the
player.
• Remove any objects that block the remote signal to
the player.
• Make sure the player is not exposed to intense light,
such as direct sunlight or fluorescent lamp.
• Move closer to the player when using the remote.
All manuals and user guides at all-guides.com
If you still have problems after trying the above
Try to reset the player.
1 Turn off the player.
2 Turn the power back on while holding down both
If the player cannot be reset in the way above,
disconnect the AC power cord and remove all the
batteries. Leave the player for a while and turn the
power back on.
If the problem persists, please consult your nearest
Aiwa dealer.
E and REPEAT/MODE.
15
ENGLISH