Bosch PST 650 PE Instrucciones De Servicio página 12

/ Offsetting the Foot Plate
D E
For sawing close to edges, the foot plate can be offset
to the rear.
– With the base plate repositioned, the cutting angle
cannot be changed.
– The circle cutter/parallel guide 22 as well as the
splintering protector 15 cannot be used.
PST 650 PE/PST 750 PE
Unscrew the screw 17 completely. Lift off the base
plate and reposition so that the screw 17 with the re-
tainer 21 fits in the front cut-out 20 of the base plate
and can be screwed into the threaded hole 19.
Before tightening the screw 17, press the base plate
to the rear until it latches.
PST 850 PE
Swing the clamping lever 5 out of the base plate 6 and
loosen the base plate by turning the clamping lever
anti-clockwise.
Slide the base plate 6 to the stop in the direction of the
blow-out opening.
Retighten the clamping lever 5 by turning clockwise
and swing back into the base plate. Take care that the
clamping lever is completely sunk into the base
plate 6.
Splintering Protector
B
To prevent the splintering of the surface when sawing
wood, insert the splintering protector into the base
plate 6 from below.
The splintering protector can be used only with certain
types of saw blades.
2 609 932 299 • (03.03) T
All manuals and user guides at all-guides.com
After working for a long period with a low stroke rate,
allow the machine to cool by running for approx.
3 minutes without a saw blade and at maximum stroke
rate.
For narrow curves, use a thin saw blade.
When sawing metal or similar material, apply a cooling
or lubricating agent along the cutting line.
F
Maximum material thickness: 30 mm
H
Plunge cutting may be used only on soft materi-
als such as wood, aerated concrete, gypsum
plaster boards, etc.!
Use only short saw blades.
Place the front edge of the base plate on the work-
piece and switch on. Press the machine firmly against
the workpiece and plunge the saw blade slowly into
the workpiece.
As soon as the complete surface of the base plate
rests on the work piece, continue to saw along the
cutting line.
English–4
Tips
/ Parallel Guide/Circle Cutter
G
(Accessory)
Plunge Sawing