Turning Off - Mecam Classic Manual De Instrucciones

NOTE: When the battery power is low, MeCam will automatically go into safe protection
mode. When this occurs, MeCam cannot be turned on. At this time, please fully charge
your device.
2. TURNING ON/OFF
STEPS. Please follow the below steps when turning your MeCam device on and off.
TURNING ON: Press and hold the Power button for three(3) seconds. The
red indicator light will then turn on and blink three(3) times. A red indicator
light will then stay on. The device is now in standby mode (ON).

TURNING OFF:

Red indicator light will then flash three(3) times and then turn off. The device
is now off.
3. VIDEO RECORD FUNCTION (On/Off)
STEPS. Please follow the below steps when turning your MeCam device's video record
function on and off.
1. Confirm the Micro-SD card is inserted into the MeCam.
2. While the device is in standby mode (solid red indicator light is displaying), press
the "Record" button until the red indicator light begins to flash. The device is
now recording.
3. Press the "Record" button shortly again to stop your recording. The red indicator
light will stop flashing (again in standby mode). The video file will automatically
be saved to the micro-SD card.
4. STILL PHOTOGRAPH FUNCTION
When the MeCam device is in standby mode (solid red indicator light is on), press the
"Photo" button once (top button/also the IR Button) to take a picture. The purple/blue
indicator light will flash once. The captured image will automatically be saved to the
micro-SD card.
Resolution: 5 megapixels
5. INFRARED (IR) FUNCTION (On/Off)
While using your MeCam device in any mode, press the Photo/IR button (top button) for
three(3) seconds. The purple/blue indicator light will then turn on, signaling that the IR
function is now operational and that you can begin to record* video or take photos.
*If a video is already recording, the red indicator light will turn purple/blue and continue to
blink, signaling that it is recording while the IR function is on. Press the Photo/IR button
All manuals and user guides at all-guides.com
Press and hold the Power button for three(3) seconds. The
3