JVC WR-MG88U Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
Recording the Video/Still Image Files
Before recording
Submerge the marine case with the camera
equipped into a bathtub or water tank full of fresh
water.
Gradually increase the amount of time the marine
case is submerged as shown below.
1st time: 5~10 seconds
2nd time: 30 seconds ~ 1 minute
3rd time: 3 minutes ~ 5 minutes (try operating
the levers and buttons while the marine case is
submerged).
NOTES
Always have someone hold the marine case for
you when diving into, or getting out of water.
If for any reason water leakage occurs, remove
the camera battery. It may cause the camera to
explode.
1
Pull the marine case power/mode switch
lever to release the lock, and switch on the
camera's power.
Rotate the lever to switch on the camera's power.
The camera's power lamp lights.
8 Switching between video/still modes
Switch modes by rotating the lever.
6
2
Press the video recording start/stop button
or the still image shooting button to start
recording.
Still image shooting button
Video recording start/stop button
3
When you have fi nished recording, rotate
the power/mode switch lever to turn the
camera's power off.
The camera's power lamp goes out.
NOTE
Sometimes, due to sudden shaking or impact to the
marine case, the camera's drop detection function
operates to switch off the camera's power.
When [VIDEO MANAGEMENT FILE IS BROKEN.
TO RECORD/PLAYBACK VIDEO, RECOVERY IS
REQUIRED. RECOVER?] is displayed, press the
REC button to recover the fi le.
Zooming
(Telephoto)
Zooming
(Wide angle)

Publicidad

Tabla de contenido
loading

Tabla de contenido