Problem
Pump has following problems:
failure to produce pressure,
erratic pressure, chattering, loss
of pressure, low water volume.
Detergent fails to mix with spray.
Engine will not start; starts and
runs rough or shuts down during
operation.
Engine lacks power.
TROUBLESHOOTING
Cause
1. Water inlet is blocked.
2. Inadequate water supply.
3. Inlet hose is kinked or leaking.
4. Clogged inlet hose strainer.
5. Water supply is over 100°F.
6. High pressure hose is blocked or
leaks.
7. Gun leaks.
8. Spray tip is obstructed.
9. Pump is faulty.
1. Detergent siphoning tube is not
submerged.
2. Detergent siphoning tube is
clogged or cracked.
3. High pressure spray tip installed.
4. Detergent siphoning check ball
stuck.
1. Engine rocker switch set to off (O or
Off) position.
2. Dirty air cleaner.
3. Out of fuel.
4. Stale fuel.
5. Spark plug wire not connected to
spark plug.
6. Bad spark plug.
7. Water in fuel.
8. Overchoking.
9. Excessively rich fuel mixture.
Dirty air filter.
24
Correction
1.
Clear inlet.
2.
Provide adequate water flow.
3.
Straighten inlet hose, patch leak.
4.
Check and clean inlet hose strainer.
5.
Provide cooler water supply.
6.
Clear blocks in high pressure hose or
replace hose.
7.
Replace gun.
8.
Clean spray tip.
9.
Contact Sears service facility.
1.
Insert detergent siphoning tube into
detergent.
2.
Clean or replace detergent siphoning
tube.
3.
Replace high pressure spray tip with
black spray tip.
4.
Free detergent siphoning check ball.
1.
Set engine rocker switch to on (I or On)
position.
2.
Clean or replace air cleaner.
3.
Fill fuel tank.
4.
Drain fuel tank; fill with fresh fuel.
5.
Connect wire to spark plug.
6.
Replace spark plug.
7.
Drain fuel tank; fill with fresh fuel.
8.
Open choke fully and crank engine.
9.
Contact Sears service facility.
Replace air filter.