Gas Cooktop Operation; Gas Control Knob Setting - FULGOR COGB 30 Manual De Uso Y Cuidado

Gas Control Knob Setting

Electric gas ignition
The gas burner use an electric ignition device located
near each burner that by means a spark igniters
ensure its surface light automatically.
Models with standard ignition
The electric ignition automatically light the surface
burners when the control knobs are turned to LITE
position.
To set:
1. Push and turn knob counter clockwise to "LIGHT",
all four or five burner surface will clicking
(sparking). Only the burner with the control knob
turned to LIGHT will produce a flame.
2. Turn knob anywhere between Hi and LO (in this
position the sparking are stop) In case flame go
out repeat the step 1.
Models with automatic re-ignition
The electronic auto re-ignition, light the surface
burners when the control knob are turned at any valve
rotation that admits sufficient gas flow to support a
flame.
If any burner flame go out due to a draft or other
adverse, the igniter automatically sparks on all
burners to relight the flame.
NOTE: this feature is provided as a convenience and
is not intended as a safety feature.
To set:
• Push and turn knob counter clockwise everywhere,
all four or five burner surface will clicking
(sparking). Only the burner with the control knob
turned from HI _ LO will produce a flame and re-
ignite automatically if the flame go out.
All manuals and user guides at all-guides.com

Gas Cooktop Operation

Models COGB
WARNING
•
Do not operate a burner using empty
cookware or without cookware on the grate.
•
Do not touch the burner when the igniters are
clicking (sparking)
•
Do not let the burner flam extend beyond the
edge of the pan.
•
Turn off all controls when not cooking.
Failure to follow these instruction can result in
personal injury or fire.
Gas burners
The gas burners design of this cooktop models, allow
a pleasing option for cooking where size, power and
simmering are a primary concern.
Burners with one ring flame
this gas burners line are engineered to match a wide
of size and power capacity. The use of this burner is
very simple just push and turn counter clockwise the
knob and set to the desired position from Hi and LO
heat level (see chart guide when setting heat level).
Its ignition device can be standard or with automatic
re-ignition.
LO
HI
Use & Care Manual
ENGLISH
MED
LO
MED
HI
002
7