Fellowes Automax 300C Manual Del Usuario página 4

DELAYED START (ON 500C ONLY)
Allows you to delay shredding for 30, 60 or 90 minutes.
DELAYED START
1 2
Open drawer and Close drawer and
add paper. (Note: Pull press clock icon on
control panel
firmly to open drawer)
**To cancel Delayed Start, press and hold Clock icon for 2 seconds
PRODUCT MAINTENANCE
OILING SHREDDER
machine could lead to issues such as diminished sheet capacity, intrusive noise
when shredding and it could ultimately stop running. To avoid these problems, we
recommend you oil your Fellowes ®
FOLLOW OILING PROCEDURE BELOW
1 2
Open paper feed drawer
Apply a light coat of
oil between two sheets and place oiled sheets in
drawer
of paper
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250.
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Drawer/Bin Door Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, see Paper Jam section under Advanced Product Features.
If a critical situation occurs while SmartLock™ is engaged and the shredder drawer
needs to be accessed, follow the steps below.
1 2
Locate the access The service hatch
will begin to rise.
screw on the back of
the machine and turn
counter clockwise with the hatch panel
is easily removed
a 6mm allen wrench.
from the top of the
machine.
* Shredder will not run if the hatch is not in place. Always replace the
hatch to resume shredding.
4
All manuals and user guides at all-guides.com
Press once for
30 minute delay
(one LED will
illuminate)
AutoMax™ shredder once per month.
3
Close the paper feed
drawer and press start to
shred the oiled sheets
3
To replace the service
hatch, position hatch
panel back on top of
the machine. Hold
panel in place while
turning the allen
wrench clockwise until
you feel resistance.
Press twice for Press three times for
60 minute delay 90 minute delay
(two LEDs will (three LEDs will
illuminate) illuminate)
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located at the bottom of the paper drawer).
TO CLEAN THE SENSORS
1
2
Turn off and unplug Locate Auto-start
shredder infrared sensor
the instruction manual. Read the entire instruction manual before
operating shredders.
shredder head or feed arms.
In case of a power outage, SmartLock™ will remain engaged.
Once power is restored, shred cycle will automatically resume.
Press four times to
reset clock
3
Dip cotton swab in
rubbing alcohol
4
away any contamination
from the paper sensors