Alarm Table - Ingersoll Rand D1300IN-W Manual Del Operador

Not resettable alarms
An alarm is defined NOT resettable (NO) when the cause that produces it persists, these types of alarms can't be directly reset by the
controller until the causes that produce them are eliminated.
When one of these alarms appear proceed as follows:
Identify the alarm code shown on controller display.
-
- Follow indications on alarm table PAR. 6.5.3. to eliminate the alarm original cause.
Reset the alarm using the procedure described on previous point.
-
if the alarm persists, try to reset pushing
-
controller display), then restart pushing the same button.
If the alarm persists call your local Ingersoll Rand distributor.
-
Quit pushing
-

6.5.3 Alarm table

Cod. 710.0145.40.11 Rev01 – 01.2013
button or wait for automatic quit.
button for 3 sec. stopping the operation process (label OFF shown on
14 - 271