Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING & CLEANING FOAM WET FILTER
1
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside-down position. Follow instructions to remove the reusable cloth filter
on page 11.
3. Carefully slide foam wet filter down over the filter cage, making sure the cage is completely covered (Fig. 2 & 3).
4. Place the power head onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside-down position, carefully remove foam wet filter (Fig. 4).
2. Use a mild soap and water solution to wash the foam wet filter and rinse with clean water (Fig. 5).
3. Allow the filter to air dry for 24 hours before installing onto the filter cage.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE TROUBLESHOOTING.
PROBLEM
The wet/dry vacuum will not
operate.
The dust comes out from the
motor cover.
Reduced efficiency and motor/
speed vibration.
2
3
TROUBLESHOOTING
POSSIBLE CAUSE
No power supply.
Faulty power cord.
Collection tank is full.
Switch in the wrong position.
The reusable cloth filter is missing or
damaged.
There are blockages in the nozzle, hose,
or the collection tank inlets.
The reusable cloth filter is clogged by
fine dust.
4
Check the power supply, cord, breakers, and
fuses.
Unplug and check the power cord. If
damaged, have it repaired by a professional.
Empty the collection tank.
Press the ON 'I' button on the power head.
Attach or replace the reusable cloth filter.
Unplug and check nozzle, hose, and
collection tank inlets for blockages.
Take off the filter and clean it or install a new
reusable cloth filter.
12
5
SOLUTION
Publicidad
