Care And Cleaning - Black and Decker EuroBrew DCME10 Manual Del Usuario

DCME10.Pub178918RV01 3/16/05
SETTING THE CLOCK (D)
1. Plug in the unit. The digital display clock flashes 12:00 a.m. until the correct
time is set.
2. Press the Hour button until the correct a.m. or p.m. hour is reached. The letters
PM appear in the upper left corner of the display.
3. Press the Min button until the correct minutes are reached.
4. When the correct Hour and Min are set, the two dots between the hour and
minute flash indicating that the time is set.
Note: Unplugging the unit will reset the clock to 12:00.
PROGRAMMING THE COFFEEMAKER FOR AUTO-BREW (D)
1. If the clock is not set for the current time of day, see
2. Be sure the On/Off button is off and the indicator light
D
3. Press the Program button and hold until the coffee cup
time, 6:00 will show on the display; otherwise time previously programmed is
displayed.
4. Using the Hour and Min buttons, program the time you want the coffee to start
brewing (for example 8:00 a.m.)
5. When programming is complete, the coffee cup symbol (
5 seconds.
6. Prepare the Coffeemaker for brewing coffee (see "To Brew a Pot of Coffee"
section), but don't turn the unit on.
7. To activate Auto-Brew, press the program button. The coffee cup symbol (
comes on and the preset brewing time is displayed momentarily. The digital
clock returns to the current time of day and the coffee cup symbol (
remains on the display indicating Auto-Brew has been activated.
8. When brewing begins, the coffee cup symbol (
light goes on.
Note: The Auto-Brew function can be canceled at any time by pressing the Auto
On button a second time. On indicator light will go out.
PROGRAMMING THE AUTO-OFF KEEP WARM FEATURE
The "Keep Warm" Plate heats up as soon as the coffeemaker is on and keeps
brewed coffee hot until coffeemaker is turned off and the on indicator light goes
out. However, it can be programmed to keep coffee warm for up to 1 hour and 59
minutes and then automatically shuts off.
1. Press the On/Off button and keep it held down. The digital clock will display
1:59. To adjust the Keep Warm time, press the Hour and then the Min button.
Note: The numerals will run backward when the Keep Warm feature is being
programmed.
2. When desired Keep Warm time has been reached, release the On/Off button.
The indicator light goes out.
3. The Keep Warm time will now be in memory and the digital clock shows the
current time of day.
12:08 PM Page 6
All manuals and user guides at all-guides.com
"SETTING THE CLOCK" section.
is out.
symbol ( ) begins to flash. When programming the first
5
) goes out after
)
) turns off and the indicator

Care and Cleaning

This product contains no user servi
personnel.
CLEANING
1. Be sure the unit is unplugged an
2. Open the Cover Remove the filt
3. Clean as follows: filter casket, ca
or they may be hand washed in
4. The Coffeemaker's exterior, cont
cleaned with a soft damp cloth.
pads. Never immerse the coffeem
5. To clean the water reservoir and
damp cloth.
CARING FOR YOUR CARAFE
A damaged carafe may result in po
breaking:
• Do not allow all liquid to evapo
Plate or heat the carafe when em
• Discard the carafe if chipped, cr
• Never use abrasive scouring pad
the glass.
• Do not place the carafe on or ne
or in a microwave oven.
)
• Avoid rough handling and sharp
MINERAL DEPOSITS AND CLOGG
Mineral deposits left by hard water
recommended every 3 months.
1. Pour white vinegar into the wate
window. Add cold water up to t
2. Insert a paper filter in the filter b
on the "Keep Warm" plate.
3. Turn on the coffeemaker and let
(till water level goes down to aro
soak for at least 15 minutes to so
4. Turn on the coffeemaker and bre
carafe.
5. Turn off the coffeemaker; empty
6. Fill the reservoir with cold water
then turn on the coffeemaker for
remaining cleaning solution. You
vinegar smell/taste.
7. Wash the filter basket and carafe