ASROCK FM2A75M-ITX Manual Del Usuario página 20

Tabla de contenido

Publicidad

All manuals and user guides at all-guides.com
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 11)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 21)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 8)
Connect the power switch, reset switch and system status indicator
on the chassis to this header according to the pin assignments below.
Note the positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may con-
fi gure the way to turn off your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to per-
form a normal restart.
20
ASRock FM2A75M-ITX Motherboard
This header can be used to
connect the remote
controller receiver.
This is an interface for the front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
TM
8 / 8 64-bit / 7 / 7 64-bit / Vista
/ Vista
This header accommodates
several system front panel
functions.
TM
64-bit OS:

Publicidad

Tabla de contenido
loading

Tabla de contenido