Reversing The Door Hinge - Haier HC125FVS Manual Del Usuario

Reversing the Door Hinge

1. Remove the top hinge cover screw and then remove the top hinge
cover. (see fig. # 1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws
holding the top hinge in place. (see fig. # 1)
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw hole plug from the opposite side and insert the
plug in the screw hole openings of the just removed screws.
(see fig. # 2)
5. Unscrew the door pin from the bracket of the lower hinge by turning
counter clockwise. Move the pin to the opposite hole and tighten.
(see fig. # 3) Tilt unit slightly towards back and remove the lower
hinge support. (see fig. # 4)
6. Loosen the screws holding the lower hinge bracket and remove the
hinge.(see fig. # 3)
7. Align the holes in the lower hinge bracket to the corresponding holes
in the opposite side of the cabinet. Insert and tighten the screws.(see
fig. # 3) Tilt unit slightly back to replace the lower hinge support.
Adjust up or down as needed until it is just touching the surface on
which that unit is placed. (see fig. # 4)
8. Align the bottom hole on the left side of the door with the pin of the
lower hinge and slide into place.
screw hole plugs
fig. # 2
English
8