Using The Inverter; Cleaning And Caring For The Inverter - Waeco SinePower SP150 Instrucciones De Uso

Convertidor de ondas seno
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 31
720.book Seite 18 Donnerstag, 29. September 2005 3:59 15
All manuals and user guides at all-guides.com

Cleaning and caring for the inverter

6.1

Using the inverter

Press the on/off switch (See fig. 1.2, Page 3) to start the inverter. When the
inverter is switched on, the "POWER" LED (See fig. 1.1, Page 3) lights up
green. If the battery voltage falls below 10.5 V for the 720-012PP or 21.0 V
for the 720-024PP, a warning signal sounds and the LED lights up yellow. If
the battery voltage falls further, the inverter switches off.
If the inverter overheats, it switches off – the LED lights up yellow.
➤ If this happens, switch off the inverter using the switch.
When it cools down, you can use the inverter again.
When operating the inverter at high load for lengthy periods, it is advisable to
start the engine in order to recharge the vehicle battery.
You can operate the inverter with the engine running or switched off. How-
ever, do not start the engine while the inverter is switched on, since the power
supply to the cigarette lighter is disconnected during ignition.
7
Cleaning and caring for the inverter
Caution!
Do not use sharp or hard objects for cleaning as these may dam-
age the device.
➤ Occasionally clean the device with a damp cloth.
18
SinePower SP150

Publicidad

Tabla de contenido
loading

Tabla de contenido