Scott ACTIFIT PRO II Manual Del Usuario página 6

BACK PROTECTOR
FB: Full Back protector
1
Protective device worn on the back intended to
reduce the severity of injuries caused by impacts to
the central back and scapula area
CB: Central Back protector
2
Protective device worn on the back intended to
reduce the severity of injuries caused by impacts to
central back.
LB: Lower Back Protector
3
Protective device worn on the back intended to
reduce the severity of injuries caused by impacts to
the lumbar region.
LEVEL
The performance is based on the amount of impact transmission measured in kN (kilo Newton).
The EN 1621-2:2014 provides 2 Levels of protection: Level 1 and Level 2. According to EN 1621-
4
2:2014: Level 1 protectors shall have an average peak force below 18kN and each single strike shall
not exceed 24kN Level 2 protectors shall have an average peak force below 9kN. and each single
strike shall not exceed 12kN.
Level 2 protectors offer higher performance than Level 1 protectors.
Level 2 protectors offer the highest Level specified by the CE standard. Due to the extra Level of
protection Level 2 protectors may be heavier, thicker and less ergonomic than the Level 1 protectors.
It is up to the responsibility of the rider to choose the correct Level of protection according to their
needs, their experience, their performance and skills.
TEMPERATURE
5
T+ means the protection is tested and certified for temperatures up to +40 degrees Celsius
T- means the protection is tested and certified for temperatures down to –10 degrees Celsius
All SCOTT protections are certified with ambient and wet conditioning. Wet conditioning testing
is used to simulate the high humidity experienced during sports.
• VII. HOW TO ADJUST YOUR PROTECTOR
CHOOSING YOUR CORRECT SIZE
It must be chosen in reference to the size indicated in the following size chart or on the gar-
ment itself. SCOTT Sports SA shall not accept any complaints arising from the use of an incor-
rect fitted protector.
VEST PROTECTOR
HEIGHT
TORSO LENGTH
ENGLISH - 6
XXXX plate
EN 1621-2:2014
c: FB: Full Back
CB: Central Back
LB: Lower Back
d: Level of protection
e: T+: High temperature impact test passed
f: T-: Low temperature impact test passed
S M
cm cm
< 170 170-180
39-44 42-47
Zone of protection
Reference for Personal Protective Equipment
that is in compliance with the European
harmonized technical standard used in the
design and CE certification
1
2
3
4
FB
FB
L
cm
180-190
44-49
5
5
CB LB
CB
LB
XL
cm
> 185
44-49